Is radon high in Milford, Connecticut?

Low. Averaging the model's ZIP-code predictions across Milford (weighted by how much of the city each ZIP covers) gives a long-term basement mean of 1.8 pCi/L - close to the US average of 1.8 and about 1.2× the Connecticut average of 1.5. That is below the EPA's 2 pCi/L "consider fixing" threshold, though individual homes still vary. Milford ranks 1 of 15 Connecticut cities on this site.

Which Milford ZIP codes have the highest radon?

Predictions for the 2 modeled ZIP codes in Milford range from 1.7 to 2.0 pCi/L in the basement. 0% of them are predicted at or above 4 pCi/L and 0% at or above 2. The city is fairly uniform, so the city-wide number is a reasonable guide for any neighborhood.

Should I test for radon in Milford?

Yes, once. The EPA recommends testing every home regardless of area. A short-term kit costs little and settles the question for your house; Milford's low predicted average describes the typical home, not yours.

What does EPA Radon Zone 1 mean for Milford?

Milford sits mainly in New Haven County, which the EPA classifies as Zone 1 - highest potential (predicted average > 4 pCi/L). The zone map dates from 1993 and covers whole counties. The newer model's city average of 1.8 pCi/L does not line up with Zone 1, which is common - the EPA itself says high-radon homes exist in every zone. Neither replaces a test of your own home.

Radon levels in Milford, Connecticut

LowEPA Zone 1

Predicted long-term basement average of 1.8 pCi/L (model estimate) across the 2 modeled ZIP codes in Milford - close to the US average of 1.8, about 1.2× the Connecticut average of 1.5. Ranked #1 of 15 Connecticut cities on this site. Most of the city lies in New Haven County.

Test Milford, CT once anyway - radon varies house to house

The predicted basement average here is 1.8 pCi/L, below the EPA's 2 pCi/L "consider fixing" threshold. That's good news for the area - but the EPA still recommends every home be tested, because foundation cracks, soil pockets and ventilation make one house very different from its neighbor. One inexpensive kit settles it.

Get a short-term test kit →Or track it with a continuous monitor

We may earn a commission from Amazon at no extra cost to you.

Predicted (model estimate). The pCi/L figures on this page are long-term area averages from a peer-reviewed national model built on millions of real radon tests (2001-2021). They describe the typical home in this area - not your home, which can be several times higher or lower. The EPA radon zone is a separate, 1993 county-level classification. How the numbers work.

1.8 ± 0.06

pCi/L predicted basement mean (model SD)

1.3 ± 0.05

pCi/L predicted upstairs (above-ground) mean

1.7-2.0

range of ZIP-level basement predictions in the city

of Milford ZIPs predicted ≥ 4 pCi/L (0% ≥ 2)

What this means for Milford

The typical Milford home is predicted below 2 pCi/L, the lowest band. That describes the average house; the ZIP-level predictions inside the city still span 1.7 to 2.0 pCi/L.

The city figure is not a separate estimate: it is the mean of the model's ZIP-code predictions, weighted by the share of the city's land in each ZIP (Census 2020 ZCTA-to-place relationship file). Note that the EPA classifies New Haven County as Zone 1 while the newer model predicts 1.8 pCi/L for Milford; where they disagree, we grade on the model but show both.

Comparable Connecticut cities: Stamford (1.6), Waterbury (1.6), Norwalk (1.6), Danbury (1.4).

ZIP codes in Milford

ZIPs that overlap the city, largest share of its land first. Predicted basement and upstairs means are model estimates; ZIPs the model does not cover show a dash.

ZIP	Share of city	Basement	Upstairs	Grade
06460	56%	1.7 ± 0.06	1.2	Low
06461	44%	2.0 ± 0.07	1.5	Low

Testing help in Connecticut

Connecticut's radon program page is at portal.ct.gov; it lists testing and certified-mitigator guidance. EPA state radon contacts page. If a test comes back at 4 pCi/L or higher, mitigation typically costs $800-$2,500 installed; use EPA find-a-professional and read the mitigation guide.

Milford radon questions

Is radon high in Milford, Connecticut?: Low. Averaging the model's ZIP-code predictions across Milford (weighted by how much of the city each ZIP covers) gives a long-term basement mean of 1.8 pCi/L - close to the US average of 1.8 and about 1.2× the Connecticut average of 1.5. That is below the EPA's 2 pCi/L "consider fixing" threshold, though individual homes still vary. Milford ranks 1 of 15 Connecticut cities on this site.
Which Milford ZIP codes have the highest radon?: Predictions for the 2 modeled ZIP codes in Milford range from 1.7 to 2.0 pCi/L in the basement. 0% of them are predicted at or above 4 pCi/L and 0% at or above 2. The city is fairly uniform, so the city-wide number is a reasonable guide for any neighborhood.
Should I test for radon in Milford?: Yes, once. The EPA recommends testing every home regardless of area. A short-term kit costs little and settles the question for your house; Milford's low predicted average describes the typical home, not yours.
What does EPA Radon Zone 1 mean for Milford?: Milford sits mainly in New Haven County, which the EPA classifies as Zone 1 - highest potential (predicted average > 4 pCi/L). The zone map dates from 1993 and covers whole counties. The newer model's city average of 1.8 pCi/L does not line up with Zone 1, which is common - the EPA itself says high-radon homes exist in every zone. Neither replaces a test of your own home.

← All Connecticut counties and cities · New Haven County · How to test · Methodology